Tema: Nuevo Firmware 1.0.6 para la 50D

What has been changed in Version 1.0.6 of the firmware?

It includes the following improvements and fixes:

1. Supports AF assist beam feature of the new flash, Speedlite 270 EX, which is scheduled to be released in April 2009In low light situations, the AF assist beam fires during autofocusing. Conditions that cause the AF assist beam to fire have been changed in Firmware Version 1.0.5 or later.If the firmware of the camera is version 1.0.3 or earlier, the AF assist beam may not fire even if the emitting conditions are met.
2. Changes the error indications that are displayed on the cameraIn previous firmware, if an error is detected, Err 99 is displayed on the camera in most cases. Firmware Version 1.0.5 or later further specifies the error indications as follows.
   Indications on the Camera's LCD monitor (XX are numbers listed on the right.)
   Err XX
   Shooting is not possible.
   Turn the power switch to <OFF> and <ON> again or re-install the battery.
   
   
   10 ---- Malfunctions related to files have been detected.
   20 ---- Malfunctions related to the mechanical have been detected.
   30 ---- Malfunctions related to the shutter have been detected.
   40 ---- Malfunctions related to the power source have been detected.
   50 ---- Malfunctions related to the electric control have been detected.
   70 ---- Malfunctions related to images have been detected.
   80 ---- Malfunctions related to the electric control or images have been detected.

• If If malfunctions in the camera are detected, "Err XX" will be displayed. A two-digit number that corresponds to the malfunctions detected by the camera will be displayed in the "XX" section of the error number. Other than the error numbers listed above, there are other numbers such as "01". In that case, provide appropriate handling and servicing by following the details displayed on the LCD monitor of the camera.

• If an error code appears frequently, the camera is malfunctioning; therefore, note down the error number and contact our service center.

1. Addresses the vertical banding noise phenomenonIf the recording format is set to sRAW1, vertical banding noise may become visible depending on the camera settings, subject, and background.This phenomenon is addressed by this firmware.

Versión con traducción al español con todos los detalles:

Versión traducida de http://web.canon.jp/imaging/eosd/firm-e/eos50d/firmware.html

Saludiños

Muchas gracias por el aviso, ya esta instalada y la probaremos a ver que tal

Saludos.

Gracias por el aviso, en cuanto llegue a casa la actualizo.-

Saludos.-

Hola: no se si alguien ha conseguido bajar dicho firmware porque yo lo he intentado varias veces desde la web de Canon Japón y la página se queda en blanco y se bloquea.
Quien lo haya conseguido que nos informe como. Gracias y saludos.

Lo acabo de descargar y no ha dado problemas. Lo he hecho desde la web de siempre (EOS DIGITAL Top Page - English) y el acceso a la 50D.

Actualizada y gracias Juan55

Muchisimas gracias por la información.

Por cierto lo he descargado desde los enlaces que han puesto los compañeros y sin problemas, solo me queda colocarlo en la 50d.

Saludos.

instalado y comprobado, todo funciona perfecto.

Una vez más. Gracias JUAN

Actualizado gracias

Idem.. actualizado, y sin problemas.. gracias